Aqara Camera Hub G2H Pro Not Detecting Motion

Step-by-step fix guide | Aqara Camera Hub G2H Pro

Try this first — Check that motion detection and notifications are switched on for the Aqara Camera Hub G2H Pro in the Aqara Home app, and that notifications for the app are allowed in your phone’s settings.

Is your Aqara Camera Hub G2H Pro showing this problem? Work through the checks below in order, starting with the quickest. Each step is safe to try yourself.

What This Problem Means

The Aqara Camera Hub G2H Pro is not picking up movement, or it is detecting movement but you are not getting alerts. Settings, placement and notifications are the things to check.

Common Symptoms

  • No motion alerts when someone walks past
  • Events are missing from the timeline
  • Alerts arrive late
  • Only some movement is picked up

Safe Checks You Can Try

1. Check the detection settings

Open the camera in the Aqara Home app and check motion detection is on and the sensitivity is not set too low.

2. Check phone notifications

Make sure your phone allows notifications from the Aqara Home app and that Do Not Disturb or a focus mode is not hiding them.

3. Check activity and privacy zones

Aqara says the G2H Pro supports activity zones and privacy masking zones. Make sure the area you want covered is inside an activity zone and not masked.

4. Check for a firmware update

Open the camera in the Aqara Home app and look for a firmware update in its settings. Leave it powered on until the update finishes.

5. Check the camera is online

Alerts need the camera to be online. If it shows offline, follow our offline guide first.

Helpful accessory: Find the Aqara Camera Hub G2H Pro
We may earn a commission from Aqara purchases made through links on this page.

When To Contact Support

If the problem is still there after these checks, contact Aqara support. Aqara’s technical support email is support@aqara.com, and you can also send feedback from the Aqara Home app. Have your proof of purchase ready in case a repair or replacement is needed.

Last resort: factory reset. Aqara’s manual says pressing the reset button 5 times resets the G2H Pro and clears its local information. You will need to add it to the Aqara Home app again, along with any Zigbee devices paired to it. Only do this if the steps above have not worked.