Tapo C630 KIT Solar Panel Not Charging? Here’s How to Fix It

Step-by-step fix guide | Tapo C630 KIT

Try this first — Check the Battery Level chart in Device Settings > Battery Status, and remember charging only restarts below about 90%.

If the Tapo C630 KIT solar panel does not seem to charge the camera, these checks come from Tapo’s solar guide.

What This Problem Means

The panel is not topping up the battery, or it is but the app does not show it.

Common Symptoms

  • The battery level keeps falling
  • No charging shown in the app
  • The camera goes flat in winter

Safe Checks You Can Try

1. Check the battery chart

Tapo’s solar guide says to open Device Settings > Battery Status: the Battery Level chart shows whether the panel is charging.

2. Know when it charges

Tapo says charging only restarts once the battery drops below about 90%, because of the charging chip, so a full battery will not show charging.

3. Test with a USB charger

Tapo says to charge the camera with a USB adapter. If that fails too, the problem is the camera, not the panel.

4. Check the panel and cable

Inspect the panel for damage, push the cable fully in, clear any shade and wipe the panel clean.

5. Point it at the sun

In the UK, Tapo says to face the panel south, tilted at 35 to 45 degrees, with no leaves or buildings blocking it.

6. Check the temperature

Tapo says the panel works from -20°C to 45°C, but the battery only charges between 0°C and 45°C.

7. Update the app and firmware

Install the latest Tapo app, then update the camera’s firmware from its Device Settings.

Helpful accessory: Tapo A201 Solar Panel — Tapo’s IP65 panel for its battery cameras, with a 4 m cable. Tapo says about 45 minutes of sun a day keeps a camera topped up.
As an Amazon Associate I earn from qualifying purchases.

When To Contact Support

If none of these checks fix it, contact Tapo support through TP-Link’s UK support site. Have the model and hardware version ready: Tapo says both are on the label on the camera.

Last resort: factory reset. Tapo’s reset guide for the Tapo C630 KIT says to tilt the lens down, lift the silicone cover and hold the raised button for 10 seconds. You will then need to set it up again in the Tapo app. Removing it in the app (long-press its card, or Camera Settings > Remove) also resets it; Tapo says a Tapo Care plan stays on your account.