Aqara Doorbell Camera G400 Not Powering On

Step-by-step fix guide | Aqara Doorbell Camera G400

Try this first — Confirm the supply: the G400 needs a stable 8-24V AC/DC doorbell transformer or an IEEE 802.3af PoE source. It has no battery and cannot run on solar.

A G400 that will not start is nearly always a supply problem. This guide covers the two power routes Aqara supports and the wiring limits it gives for each.

What This Problem Means

The G400 is a wired-only doorbell. If the voltage is wrong or unstable, or the Ethernet link is not delivering PoE, the doorbell cannot boot.

Common Symptoms

  • No lights or sounds from the doorbell
  • It works on PoE but not on doorbell wiring, or the other way round
  • The old chime does not ring

Safe Checks You Can Try

1. Check which supply you are using

Aqara supports PoE (IEEE 802.3af) or existing doorbell wiring at 8-24V AC/DC. Nothing else will power it, including batteries and solar panels.

2. Check the transformer output

The transformer must give a stable output within the 8-24V range. A transformer that cannot hold a stable voltage can stop the doorbell starting.

3. Check the PoE cable and source

Use Cat5e or higher, keep the cable between the doorbell and the PoE device to 100 m or less, and make sure your switch or injector supplies 802.3af power.

4. Do not expect your old chime to work

Aqara states that the G400 does not work with a traditional chime on existing wiring. It ships with its own plug-in chime instead, so a silent old chime is not a power fault.

5. Using your original bell

Aqara’s manual says that integrating the original bell needs an Aqara Single Switch Module T1 (With Neutral) or Dual Relay Module T2, plus an additional hub. Because of the high-voltage risk, a qualified electrician is strongly recommended.

Helpful accessory: Find the Aqara Doorbell Camera G400
We may earn a commission from Aqara purchases made through links on this page.

When To Contact Support

If the supply tests correctly and the doorbell still shows no signs of life, contact Aqara support at support@aqara.com. Do not work on mains wiring yourself.

Need a hand with this?

If the wiring, transformer or power supply is beyond a DIY job, it is worth having a qualified electrician look at it. You can compare up to 3 quotes from local electricians.

We may earn a commission if you request quotes through this link, at no cost to you.

⚠️ Important: This page is for guidance only. Always turn off the power at the circuit breaker or fuse box before touching any wiring, and use a qualified electrician if you are not sure. Follow Aqara’s official guidance for your device.