Aqara Smart Rim Lock U500 Alarm or Alert Keeps Sounding: How to Stop It

Step-by-step fix guide | Aqara Smart Rim Lock U500

Try this first — Close the door fully and lock it. Aqara says the lock warns if the door is not locked after 5 seconds or not closed after 10 seconds.

Is your Aqara Smart Rim Lock U500 showing this problem? Work through the checks below in order, starting with the quickest. Each step is safe to try yourself.

What This Problem Means

The Aqara Smart Rim Lock U500 keeps beeping or announcing an alert. Most of the time it is the door-not-closed or door-not-locked alert, which you can adjust.

Common Symptoms

  • The lock beeps after the door is opened
  • A door-not-locked alert keeps sounding
  • Alerts sound at night
  • The alarm sounds when someone tampers with the lock

Safe Checks You Can Try

1. Close and lock the door

Aqara says the door-not-locked alert sounds after 5 seconds and the door-not-closed alert after 10 seconds. Both are on by default.

2. Adjust the alert times

Change the timings, or switch the alerts off, in the Aqara Home app under Voice and Sound Settings.

3. Use Do Not Disturb

Aqara’s Do Not Disturb mutes general alerts during set hours but still warns about forced entry and a door left ajar.

4. Turn the volume down

Press Set to enter setup mode (an admin fingerprint or PIN may be needed), then press 3 to adjust the volume and language.

5. Calibrate the lock

Keep a key with you, then close the door and leave it unlocked. Press Set once to enter setup mode, press 5 and follow the voice prompts: open the door fully, close it from inside and lock it. Aqara says the lock will not work properly until calibration is done, and not to calibrate when the battery is low.

Helpful accessory: Find the Aqara Smart Rim Lock U500
We may earn a commission from Aqara purchases made through links on this page.

When To Contact Support

If the problem is still there after these checks, contact Aqara support. Aqara’s technical support email is support@aqara.com, and Aqara’s UK shop lists a support line on 01384 414 200. Aqara’s UK shop lists a 2-year warranty. Have your proof of purchase ready in case a repair or replacement is needed.

Last resort: factory reset. Open the battery cover on the inner panel and hold the Reset button for 5 seconds, then follow the voice prompts and verify with an admin fingerprint or PIN. Aqara says this resets the lock, so you will need to set it up and add your users again. Only do this if the steps above have not worked.