Ring Alarm Contact Sensor Not Working

Step-by-step fix guide | Ring Alarm Contact Sensor (2nd Gen)

Try this first — Take the Contact Sensor within about 5 feet (1.5 m) of the Base Station and see if it connects there.

Is your Ring Alarm Contact Sensor (2nd Gen) offline, not responding, or showing a door as open when it is shut? These checks come from Ring’s UK Contact Sensor guide.

What This Problem Means

The Contact Sensor uses two CR2032 3V batteries, which Ring says last up to 3 years, although cold drains them faster. It connects to the Base Station over Z-Wave (Ring lists up to 76 m in open air) and is for indoor use only (0°C to 49°C). Ring says the gap between the sensor and its magnet must be no more than 2.54 cm.

Common Symptoms

  • The sensor shows as offline in the Ring app
  • A door or window shows as open when it is closed
  • No light on the sensor

Safe Checks You Can Try

1. Test it near the Base Station

Ring says to move the sensor to within 5 feet of the Base Station. If it works there, move the Base Station somewhere more central or add a Range Extender.

2. Reseat the batteries

Remove the batteries for a few seconds and put them back in. If the sensor shows no lights at all, Ring says to replace the batteries (two CR2032 3V).

3. Retry the connection

In the Ring app, tap the Alarm tile, then Connected Devices, choose the sensor, tap Device Settings, then Advanced Options and Retry Connection, and follow the prompts. If that fails, Ring’s next step is Reconfigure Device, and after that Remove Device and adding it again.

4. If it says open when the door is shut

Ring’s fix is to check the magnet and the sensor line up. Ring’s UK shop lists the maximum gap between them as 2.54 cm.

5. Check for interference

Ring says Alarm signals are weakened by brick, concrete or metal walls, metal-backed insulation, heavy wooden beams, large mirrors, fish tanks and large appliances, and by other wireless devices such as cordless phones, wireless speakers, Bluetooth devices, baby monitors and other Wi-Fi. It recommends keeping sensors away from TVs, computers and microwaves.

When To Contact Support

If the sensor still will not connect or report correctly, contact Ring through its UK help centre.

Last resort: factory reset. For the 2nd Gen sensor, Ring says to slide it off its base, press and hold the pinhole reset button on the back until the light turns off, then add it back in the Ring app.