Ring Alarm Motion Detector Not Working

Step-by-step fix guide | Ring Alarm Motion Detector (2nd Gen)

Try this first — Take the Motion Detector within about 5 feet (1.5 m) of the Base Station and see if it connects there.

Is your Ring Alarm Motion Detector (2nd Gen) offline, showing as tampered, or triggering when it should not? These checks come from Ring’s UK help pages.

What This Problem Means

The Motion Detector runs on two AA batteries, which Ring says last about 3 years, and connects to the Base Station over Z-Wave (Ring lists up to 76 m in open air). Ring lists it for indoor use only (0°C to 49°C), mounted in a corner or on a flat wall.

Common Symptoms

  • The detector shows as offline in the Ring app
  • A tamper alert
  • Alerts when nobody is there, for example from pets
  • No light on the detector

Safe Checks You Can Try

1. Test it near the Base Station

Ring says to move the detector to within 5 feet of the Base Station. If it works there, move the Base Station somewhere more central or add a Range Extender.

2. Reseat the batteries

Remove the batteries for a few seconds and put them back in. On the 2nd Gen detector, Ring says to also press the button on the front cover. If there are no lights at all, replace the batteries.

3. Retry the connection

In the Ring app, tap the Alarm tile, then Connected Devices, choose the Motion Detector, tap Device Settings, then Advanced Options and Retry Connection, and follow the prompts. If that fails, Ring’s next step is Reconfigure Device, and after that Remove Device and adding it again.

4. Clear a tamper alert

Ring’s fix is to remove the back cover, press and hold the tamper button for 5 seconds, then snap the cover back on. If it still shows as tampered and is screwed to the wall, Ring says to loosen the screws and reseat the detector on its mounting bracket.

5. If pets set it off

Ring says the detector ignores pets under 3.5 stone (22 kg) when it is mounted 2.1 m above the floor and set to its lowest motion sensitivity, so check the mounting height and the sensitivity setting in the Ring app.

6. Check for interference

Ring says Alarm signals are weakened by brick, concrete or metal walls, metal-backed insulation, heavy wooden beams, large mirrors, fish tanks and large appliances, and by other wireless devices such as cordless phones, wireless speakers, Bluetooth devices, baby monitors and other Wi-Fi. It recommends keeping sensors away from TVs, computers and microwaves.

When To Contact Support

If the detector still will not connect or keeps alerting, contact Ring through its UK help centre.

Last resort: factory reset. For the 2nd Gen detector, Ring says to keep the batteries in, remove the back cover and press and hold the pinhole reset button until the light turns solid red. Then add it back in the Ring app.