tado Smart Thermostat X (1st Gen): Change the Batteries

Step-by-step fix guide | tado° Smart Thermostat X (1st gen)

Try this first — Use three new AAA alkaline (LR03) batteries and replace all three at the same time.

The 1st generation Wired Smart Thermostat X runs on three AAA batteries. This is how tado says to change them.

What This Problem Means

tado tells you to use only the listed battery type, not to mix types, not to mix old and new, and to match the plus and minus marks.

tado does not recommend Duracell Optimum batteries, because it says they are slightly too short for the compartment.

Common Symptoms

  • Depleted-battery symbol on the display
  • Thermostat dropping offline or going blank
  • Heating not responding to the thermostat

How to Do It

1. Remove the thermostat from the backplate

Grip the outer edge and gently pull it away from the wall.

2. Replace the batteries

Put in three new AAA alkaline (LR03) batteries, all at the same time.

3. Put it back

Place the device back on the backplate and press it into place.

Helpful accessory: Find the tado° Wired Smart Thermostat X
We may earn a commission from tado° purchases made through links on this page.

When To Contact Support

If the problem is still there after these checks, contact tado° support through the tado° Help Centre (help.tado.com). If you bought it from tado.com or an authorised retail partner, it may be covered by tado’s 2-year Premium Warranty, which tado says includes remote diagnostics and a rapid replacement if a hardware defect is confirmed. Products bought from eBay, Amazon Marketplace and other secondary sellers are not covered. This guide follows tado’s Help Centre article on changing batteries in tado° X devices.

Good to know. tado says that if you disconnect the Bridge X and there is no other Thread border router, batteries drain much faster. In summer, tado suggests setting rooms to OFF. If the thermostat still reads low on power, see our low battery guide.

Need a hand with this?

If you are unsure about the thermostat wiring or the boiler connection, a heating engineer can fit it or find the fault. Any work on the boiler itself must be done by a Gas Safe registered engineer. You can compare up to 3 quotes from local heating engineers.

We may earn a commission if you request quotes through this link, at no cost to you.

⚠️ Important: This page is for guidance only. Heating systems vary. Turn off the power before touching any wiring, and if a radiator valve is seized, damaged or leaking, stop and contact a heating engineer. Follow tado°’s official guidance for your device.