If the Tapo C230 misses people or sends no motion alerts, work through these checks from Tapo’s detection guides.

What This Problem Means

Something is moving in view but the camera is not detecting it, or is not telling you.

Common Symptoms

• No motion alerts
• People walk past without a clip
• Alerts arrive late or miss the start

Safe Checks You Can Try

1. Turn detection on

Tapo’s detection guide says to open Live View > Device Settings > Detection, turn on the detection types you want and set the sensitivity.

2. Check the detection zone

Under Detection Zones, check the zone covers the area you care about. With no zone set, the whole picture is used.

3. Don’t point it through glass

Tapo says glare and infrared reflection at night cause missed or wrong detections through a window.

4. Check the height and angle

Tapo says detection depends on the mounting height, angle, sensitivity and zones. Plug-in cameras use AI that looks for pixel changes in the picture.

5. Too many false alerts?

Tapo’s false alert guide suggests turning on person detection, turning basic motion detection off if you only want people, and setting a zone that leaves out trees, roads and car lights.

6. Update the app and firmware

Install the latest Tapo app, then update the camera’s firmware from its Device Settings.

When To Contact Support

If none of these checks fix it, contact Tapo support through TP-Link’s UK support site. Have the model and hardware version ready: Tapo says both are on the label on the camera.

Last resort: factory reset. Tapo’s reset guide says to press and hold Reset with a pin for about 5 seconds until the light blinks red. On pan-tilt cameras, tilt the lens up to reach the Reset button. You will then need to set it up again in the Tapo app. Removing it in the app (long-press its card, or Camera Settings > Remove) also resets it; Tapo says a Tapo Care plan stays on your account.