Tapo C230 Offline? Here’s How to Fix It

Step-by-step fix guide | Tapo C230

Try this first — Check the status light, then restart your router and the camera.

If the Tapo C230 shows offline in the Tapo app, work through these checks in order. They come from Tapo’s own connection guide.

What This Problem Means

The camera has lost its connection to your network or to Tapo’s cloud, so live view, alerts and new cloud clips stop.

Common Symptoms

  • The camera shows offline in the Tapo app
  • Live view will not load
  • No new alerts or clips

Safe Checks You Can Try

1. Check the status light

Tapo’s status light guide says on most cameras solid red means starting up, red and green blinking means ready for setup, red blinking slowly means connecting to Wi-Fi, solid amber means connected to your network but not the cloud, and solid green means connected to the cloud.

2. Check the power

Tapo says to use the original power adapter at its rated voltage, and not to use extension cords.

3. Restart the camera and router

Tapo suggests rebooting your router and the camera, then closing and reopening the Tapo app.

4. Check the Wi-Fi signal

In the Tapo app, open Device Settings > Device Info: the Wi-Fi icon shows the signal strength. Tapo’s network guide says above -50 dBm is strong, -50 to -70 dBm is good, and below -70 dBm is poor. If it is poor, move the router or camera closer, or add a Wi-Fi extender or mesh system.

Ad · Kit that may help

If the signal is weak, the step above suggests adding an extender. A mesh system is the whole-home alternative.

TP-Link RE315 range extender

Plugs in part-way between your router and the device and repeats the Wi-Fi signal.

TP-Link Deco X10 mesh system

Deco units work together to cover the whole home with one Wi-Fi network.

From TP-Link: its Wi-Fi guide lists the RE315 among its range extenders and calls Deco mesh its recommended whole-home option (checked 23 October 2026).

Worth knowing: Tapo’s offline guide also suggests a range extender or a mesh network when the signal is weak.

We earn commission if you buy through these buttons. As an Amazon Associate I earn from qualifying purchases.

5. Move it away from interference

Tapo says microwaves, Bluetooth devices, USB 3.0 devices, baby monitors and Zigbee devices near the camera can interfere with it.

6. Check the router settings

Tapo suggests these router settings: 2.4GHz channel 1, 6 or 11, a 20MHz channel width, WPA2 or WPA3-Personal security, and Smart Connect (or Wi-Fi optimising) turned off. Your router’s manual shows where these are.

7. If it only fails away from home

Tapo suggests setting your router’s DNS to 8.8.8.8, temporarily turning off antivirus, firewall or security software, and testing with a mobile hotspot.

8. Update the app and firmware

Install the latest Tapo app, then update the camera’s firmware from its Device Settings.

When To Contact Support

If none of these checks fix it, contact Tapo support through TP-Link’s UK support site. Have the model and hardware version ready: Tapo says both are on the label on the camera.

Last resort: factory reset. Tapo’s reset guide says to press and hold Reset with a pin for about 5 seconds until the light blinks red. On pan-tilt cameras, tilt the lens up to reach the Reset button. You will then need to set it up again in the Tapo app. Removing it in the app (long-press its card, or Camera Settings > Remove) also resets it; Tapo says a Tapo Care plan stays on your account.