If the Tapo C645D KIT will not pan or tilt, moves slowly or stops at the wrong place, these are the checks from Tapo’s pan and tilt guide.

What This Problem Means

The motor is not responding properly, or the camera has lost track of its position.

Common Symptoms

• It will not move from the app
• It stops short and says it has reached the maximum
• Tracking leaves it pointing the wrong way

Safe Checks You Can Try

1. Check it opens normally

Tapo’s pan and tilt guide says to check the camera opens normally in the app first.

2. Check nothing is blocking it

Gently move the lens by hand to check nothing is in the way.

3. Run Pan & Tilt Correction

Go to Device Settings > Pan & Tilt > Pan & Tilt Correction (or the icon in the top corner of the Pan & Tilt controls in live view). It resets the lens to its default position.

4. If it says it has reached the maximum extent

Tapo says to tighten the card-slot screws and seat the rubber seal, run the correction and reboot. If it keeps happening every few days, turn on Auto Reboot (Device Settings > Reboot Camera).

5. If it is slow or freezes

Check the battery is charged and the Wi-Fi signal is good where it is mounted.

6. Check tracking settings

Motion Tracking is under Device Settings > Detection. Tapo says the camera returns to its default position 30 seconds after the last event, and will not return while events continue; lower the sensitivity if it stays turned away.

When To Contact Support

If none of these checks fix it, contact Tapo support through TP-Link’s UK support site. Have the model and hardware version ready: Tapo says both are on the label on the camera.

Last resort: factory reset. Tapo’s reset guide for the Tapo C645D KIT says to press and hold the Reset button on the back of the larger block for 10 seconds. You will then need to set it up again in the Tapo app. Removing it in the app (long-press its card, or Camera Settings > Remove) also resets it; Tapo says a Tapo Care plan stays on your account.